WWS Spoke Calculator
With the help of the spoke calculator, you can enter a WWS article number for easy ordering of spokes from your dealer. Please observe the following instructions.
Have the following measuring equipment ready
- Caliper gauge
- Protractor or set square
- Ruler
- WWS sketch for dimensioning the spokes
Graphical representation of the spokes
On monitors with a minimum width of 1500 pixels, the calculated spokes are displayed so that you can compare them visually with the original. You can also use the WWS spoke calculator on smaller monitors, though without a visual representation of the spokes.
Proceed as follows
Important: Firstly, you must calibrate the spoke calculator using the ruler (top right) so that the spoke is displayed on the screen in its original size. To do this, ideally hold a similarly sized ruler at the beginning and end and compare them for conformity.
- Measure your pattern with your measuring equipment
- Enter the values determined into the spoke calculator
- Check by comparing your pattern with the spoke displayed in the spoke calculator
You can also build a spoke on the screen without measuring your spoke pattern beforehand - simply by entering values in the spoke calculator - and compare it with your spoke. No guarantee can be given for the comparison between the sample available to you and the spoke being built up on your screen.